Sink and pedestal console installation 1.
American standard pedestal sink installation instructions.
Bolt pedestal to the floor.
Dimensions of fixtures are nominal and may vary within the range of tolerances established by ansi standard a112 19 9.
Bottom of brace should be 26 1 2 673 mm up for floor.
Here s how to install it.
Connect the basin to the wall.
No responsibility is assumed for use of superseded or voided pages.
Two 2 x 8 50 x 203 mm wood braces to wall studs.
Check the manufacturer s instructions on your sink.
And extend a minimum of 12 305 mm to either side of.
Installation instructions supplied with lavatory.
Apply a bead of sealing putty on the underside of the drain see detail a in order to ensure a watertight seal between the sink and the drain.
Cut out part of the wallboard to reveal the studs.
These measurements are subject to change or cancellation.
Install the mounting brace.
Some pedestal sinks require a support board behind the finished wall for extra strength.
Remove excess putty after installing drain on sink.
Stops 1 5 8 41mm to either side of center.
Notch the studs for the support board with a jigsaw.
Space supplies hot cold screwdriver.
Attach the mounting bracket.